Pixel Watch 2 Charging Stand

This is a charging stand for the Google Pixel Watch 2.

Edit: Added a v2 which features much less open space at the bottom of the ring and made the ring flush with the stand.  This version is a bit of a tighter squeeze, so I'll be leaving the original available as well.

Printed with supports for the main body, I also used a raft for better bed adhesion although this is almost certainly unnecessary.

Assembly is straight forward: 

• String the cable through the main body via the charger opening
• Slide the inner ring around the charger
  • This is directional and is intended to have the inner channel facing towards the front, this ensures that the charger is inline/proud of the face to make charging easier.
  • If you have issues getting the watch to attach to the charger, pop the ring out and reverse it.
• Press the charger firmly into the main body, 
  • this is a press fit to ensure the ring doesn't move but should slide relatively easily
• Pull the charging cable taunt along the channel on the bottom of the stand and slide on the bottom panel.

Removing the charger assembly can be done easily with a flathead screwdriver through the bottom opening after removing the bottom plate.

Printer Settings:

• Ender 3v2 Sprite (Direct Drive Extruder)
• Filament: eSUN ePLA-Lite
• Slicer: Cura
• Supports: Yes (Main body only)
• Bed Adhesion: Raft
• Layer Height: 0.28mm
  • Initial Layer Height: 0.2mm
• Bed Temp: 60C
• Infill: 18%
• Pattern: Cubic Subdivision
• Print Speed: 85 mm/s
• Print Cooling Enabled
   

Adapted design by adjusting the inner ring so that it can be printed separately, additionally holds the charger slightly proud of the stand to allow for easier connections.