Filamentrollenhalter / Filament roll holders

Wandhalterung für Filamentrollen / Wall mount for filament rolls
17h 34m
1× print file
0.20 mm
0.40 mm
170.00 g
5
35
1
292
updated October 19, 2023

Description

PDF

Dies ist eine Wandhalterung für Filamentrollen. Zusätzlich zu den beiden Halterungen werden noch 2 Stäbe/Robe mit 12 Millimeter Außendurchmesser und 4 Schrauben (4x50) benötigt. Der Abstand zwischen den Haltern sollte einen Meter nicht überschreiten. Je nach Länge der Stäbe / Rohre, kann die Länge und somit die Spulenanzahl verändert werden.

Ich habe PLA und einen Füllgrad von 20% gewählt. 

 

This is a wall mount for filament rolls. In addition to the two holders, 2 rods/tubes with an outer diameter of 12 millimetres and 4 screws (4x50) are needed. The distance between the holders should not exceed one metre. Depending on the length of the rods/tubes, the length and thus the number of spools can be changed.

I chose PLA and a filling degree of 20%.

Tags



Model origin

The author marked this model as their own original creation.

License