V0 Sherpa Mini EBB36 Toolhead Mount Remix (UPDATED - Ver. 2)

UPDATE: Version 2 uses the same holes that mount the EBB36 to interface with the extruder mounted standoffs and moves the bottom holes approximately 16mm downward to create more clearance for hotend wires from the terminal block. The previous version had an issue where said wires could catch on the stock left rear motor mount and cause rubbing or other issues. Overall this causes the strain relief to be closer to the top of the stock top hat, but sleeving this wire should be sufficient to protect the wires from rubbing the panels.

________________________________________________________________________________________________________________

A simple mash of two models to create a strong body that holds the EBB36 well while keeping the form factor and mounts necessary to securely mount to the Sherpa Mini extruder and V0 rail carriage in a rigid manner, while still providing screw access. Also has the added benefit of some cable tie holes for cable management. 

This model combines the circular hub and strain relief of the design by djos_1475 with the mounting holes necessary for a Sherpa Mini on a DragonBurner setup (design by YuriO) to rigidly mount to both the extruder and the rail carriage.