Minted: BoboVR M2 to M3 - Quest 3 - Printable retrofit

I remixed a remix 
Changes from original
- Hole moved to middle (More wiggle room can bring closer to face)
- Hole raised up closer to the edge (Left and right side are now provided). Increases distance between Q3 arm and the BOBO band
- Groove added incase you really need to push it in. (For storage or getting super close)
- Reduced the thickness of the circle clip mechanism. To allow it to bend more. Should be less brittle and allow PLA to be used

I still recommend scaling it up to 101-102.5% (FOR ALL PARTS)
Test this out by printing out an arm and test fitting it (Compare it to the original)

Other notes:

Make sure to remove the bobo strap before tinkering around with it
Have pry tools ready for the White shroud/facades
Use a small flat head to pry the metal looking stickers, and use them for later/reapply them (No need for new glue, if kept dust free)

Changelog 

3/12/23
- Thickened arms for durability

- Reduced insert height, to be have more friction with the rubber O ring

Note: I now use 101% scale up

- Hole moved to middle (More wiggle room can bring closer to face)
- Hole raised up closer to the edge (Left and right side are now provided). Increases distance between Q3 arm and the BOBO band
- Groove added incase you really need to push it in. (For storage or getting super close)
- Reduced the thickness of the circle clip mechanism. To allow it to bend more. Should be less brittle and allow PLA to be used