Mosquito Zapper Holder

A wall-mountable holder for a 38mm (max) diameter handle of a mosquito zapper. My zapper is 36mm diameter and it fits comfortably with a bit of wiggle room. Probably could go to 38mm, or else you can just make it a bit larger in the slicer (or smaller, as needed).

You could of course mount anything in this – flashlights, tools, pens, etc. But its primary purpose was to mount the zapper. The reason is that the zapper has no hooks, and is awkward to just lay on the desk. It also does not lean easily and tends to fall over. So now it will never fall over, I hope.

I stuck it to a glass door, as shown in the photo, using 3M Command picture hanging strips. I actually used 1.5 strips to cover the full surface, just to add a bit of support.

This prints nicely with the 0.3mm Draft preset, 20% fill.