Apple Watch Stand with Drawer

This is a desktop or nightstand charging and storage station for any size or model of Apple Watch. This was printed on my Bambu Labs X-1 Carbon in Bambu Labs own Lavender Blue (12700) tough PLA. It prints in two parts, the first is the main body, oriented on its back and the second is the drawer oriented on its bottom. No support is needed, however you can enable supports to get a more clean watch charging puck recess. This fits the newest charging puck, since I don't have an old one, I am not sure the dimensional difference, so it may fit. 

I printed standard settings across the board, 0.2mm layer height, no brim, supports enabled, with 15% sparse infill. 

This takes approximately 100g of filament and around one hour with no supports or two hours with optional supports to get a cleaner fitment. The tolerances on the drawer are very nice, allowing a very easy open/close operation with little wiggle room. 

This design was made by me in Onshape. Feel free to open the CAD file and use it as a jumping off point to modify it to fit any other parameters you may have.