Gillette Styler No 1 Comb

My black print in PLA is strong but was a bit rough testing it; perhaps with no raft this would be the go-to.   Yellow images represent an ABS print that was brushed with acetone to smooth it out.   Clear is PETG with lots of brim no raft.

Choose a smooth plastic like ABS or PETG.

Check layer height (I used 0.34mm) when slicing vs the small combs since those are only going to be a few layers tall.

Updated with picture of brushed ABS piece (green is color from my brush).  Even though this was on a raft it feels the smoothest on the face and quite acceptable.

Original created by Thingiverse user Adom.

Modified to size similar to a stock No. 1 size comb; removed bulk from back of comb.