Ryobi Power Tool Pegboard Holder with two rails

2023-11-20 - I have added a 15mm offset for the Ryobi 18v One+ PSP02 Handheld Electrostatic Sprayer.  This allows it to sit very well against the pegboard.  This same model also works for the Ryboi Airstrike 18v One+ P320 Brad Nailer which allows the tool to hang out away from the wall, so far it is holding up great with ASA filament.

2023-10-16 - Updated files with better angled/pitched version as the original had an incorrect bevel.  I have also included a single long rail that takes up a smaller span, allowing for more tool mounts within a given area.  Finally I have also included a 17mm taller version to allow for the dust output from the Ryobi P440 One+ ¼ sheet palm sander.

For the ASA I would advise you use the high temp plate, glue stick, and print a single item at a time.  

Bambu Lab specifics for the prints: 

• Rails:
  • Walls: 3 wall loops
  • Top/Bottom Shell: monotonic top/bottom with rect infill
  • Sparse Infill: 18% gyroid infill
• Main Body: 
  • Walls: 2 wall loops
  • Top/Bottom Shell: monotonic top/bottom with rect infill 
  • Sparse Infill: 18% gyroid infill

Original Post:

This is my first attempt at sharing a model, please be kind.  

@theamzngq ‘s model was great but I wanted to be able to rotate the flat base.  I have a lot of Ryobi tools and I will randomly buy new stuff as I need it, being able to rotate the flat base means I am no longer stuck with printing a new one depending on how I want it rotated.  I simply slide the old base off the rails and rotate it at-will.

The angled one is after reading the suggestions from the feedback on his model and I really like how it presents the common shaped tools better (drill, drivers, impacts, etc).

I printed most of these using Bambu PLA though but I also have a few with Bambu ASA too.  For ASA I would leave the brim on to ensure it prints appropriately and does not warp during the cool down.  I used the textured PEI plate with no issues for the tough and I used glue on the hot-plate for the ASA.

Enjoy!

Updated the model from @theamzngq 

• Added a second rail to help hold the base to the pegboard. 
• Flat model can now be rotated in both directions.
• Created an angled/pitched version with two rails.