Atomic Pi Case

I printed on a Bambu X1C, and it was a 6 hour print (both pieces combined)

I used M3 Screws with Allen heads and M3 nuts where possible.

• Atomic Pi SBC
• PSU : meanwell RS-25 5V 25W (https://a.co/d/69WUNtH)
• Antennas:  WiFi Antenna 8dBi Omni RP-SMA Male (https://a.co/d/8i51tnt)
• Antenna adapters: HiLetgo 5pcs IPX IPEX-1 U.FL to SMA Female Pigtail Antenna (https://a.co/d/fcsiCEU)
• Power Button:  Momentary Push Button Switch 22mm 110V (https://a.co/d/bTOjnx3)
• Atomic Pi Battery: CMOS Battery with Wire Leads and MOLEX (https://a.co/d/5bkOOLN)
• USB 2 Breakout:  USB to DIP Adapter 2.54mm (https://a.co/d/a789a2p)
• Power Outlet:  IEC 320 C14 Male 3 Pins Screw Mount Inlet AC (https://a.co/d/4lpuyN2)