Simple mount for two buck converters with JST connectors
12
91
2
572
updated October 1, 2023

Description

PDF

To assemble you need:
 

  • 2x Buck converter
  • 6x M3x4 counter sunk screws
  • 2x JST PH 2 pin housing
  • 1x JST PH 3 pin housing
  • Cables and solder equipment

I found that the mount slides on the DIN rail, this most likely is because I used ABS to print. I fixed this by adding a rubber pad to the bottom.

 

See assembly on stream:
 

Model origin

The author remixed this model.

DIN Rail Bracket
by Fabian
Original model was switched to draft or deleted

Differences of the remix compared to the original

Now for buck converter

License