Bambu Labs X1C / P1S Secondary Carbon Filter

A carbon filter that attaches to the back back of a Bambu Labs X1C and P1S over the exhaust fan.

Requires:

4X M3 Countersunk Bolts ( 6mm, preferred but up to 20mm should work).

4X M3 Heat set Threaded inserts ( 5mm long and about 5mm diameter)

About 1KG of Carbon pellets 

Magnets 4+ ( 10mm, 6mm round or rectangular smaller that 10x15mm.  5mm or thinner for the 10mm but the rest are unlimited mostly. )

2 Versions

• 3D printer only version requires no post processing or extra hardware but has lower airflow and in my opinion does not look as good. 
• Mesh version requires 2 pieces of mesh ( like fly mesh or similar that is thinner than 0.2mm or there abouts ). You need to pause the print after a few layers put the mesh over the print held down with some blue painters tape and start the print again. then just trim the excess once complete. 0.2mm layers or higher are preferred , pause at layer ~3 ( Lid) and ~7 (Base, ).