Fishing Rig Keeper/ Holder

It is inspired by the rigrap design but since they are harder to get I decided to make a printable version.

It is 2 to 3 hours to print and only requires support on the posts in the middle. 

No Brim

Support only on the center posts on the plate.

Printed in PLA but should work with PETG.

It is designed to friction fit to keep it closed. Some creaking is normal, hinge can be sanded to make it quitter but not suggested as it many not stay closed.

The hole is designed to just fit a paper clip and will require some pliers to install one. It is designed to be friction fit so a firm hand is needed. I had more success getting in when I fit the metal paper clip in to each hole first, then fully assembled.