Voron 2.4 / Trident Top Hat Logitech C920 camera mount

…Please be sure to hit like & post a make, I'd love to see your prints!

For use with model: 

https://www.printables.com/model/594894-voron-24-trident-canopy-top-hat-remix-split-model-

This clip will keep your top panel sealed & secure in use & during maintenance. This clip simply slots into the upper pattern of the top hat / canopy model & mounts the C920 camera for a top down view outside the heat of the enclosure.

There are 2 models, only difference is the camera slot dimensions. Low & wide, or taller & shorter.

Check out my top panel clips here!

https://www.printables.com/model/594894-voron-24-350-trident-canopy-top-hat-remix-split-mo

Print models on the Long flat side so it looks like a  letter “U”, add supports on the overhanging part of the camera mount on the long side.

No other supports required. Print at standard Voron Print settings in ABS/ASA preferably.

Please make sure your printer is set up well for this, the tolerances are very tight 0.1-0.2mm! Any less than perfect setup might cause the prints not to fit well or at all!

This is not a reason for a bad review, these models are known to fit the main top hat / canopy model perfectly & hold with good force. If you have trouble with the fit please adjust your print settings or seek some assistance with your print profile or mechanical setup.