FLSUN V400 Filament Guide

Ok, so I wanted a guide to feed from my dryer to my new V400.
28
234
1
1847
updated September 25, 2023

Description

PDF

Ok, so I wanted a guide to feed from my dryer to my new V400. There was a simple one available but I did not have magnets. As a temporary solution I used a cable clip with some Bowden tube:

https://www.thingiverse.com/thing:5738338

From that it grew into this. Sometimes I look at it and think it is too much, but then later I like it. Anyhow posting here in case anyone else wants it.

The same cable clip is used to connect to frame. Bowden tube slides into it (guess could use without as well). I pushed my tube in reverse to the natural curve thinking the friction would help hold tube in place. Works fine so far. If the tube moves I will just use a little tape on the outside of one end.

There are slots for 2 clips. You only need one really. The second I added for those who have printed heat risers for the top. I am not sure how the fit is with risers as I have yet to print mine. Please leave feedback if using riser.

Supports are need unfortunately and I used a brim to be safe. The Bowden tube holes should be blocked. Including the slice I used for my V400.

Print Settings

Printer Brand:

Flsun

Printer:

Flsun V400

Rafts:

Yes

Supports:

Yes

Resolution:

.2

Infill:

30

Filament: Flashforge PLA Burnt Titanium


Notes:

Block Bowden hole from supports

Category: 3D Printer Accessories

Tags



Model origin

The author marked this model as their own original creation. Imported from Thingiverse.

License