Baby Sidon - multi-colour print

Even the mighty Prince of the Zoras was once a helpless hatchling
This is an exclusive model available only to supporters of the creator.
Your funds support the creator's further activity.
$5 /month
1
0
173
updated January 25, 2024

Description

 

 

Printing tips: 

This is a 5 colour model. You can get away with four colours if you use only one shade of red instead of two (simply assign both reds to the same filament, or fill in the light-red highlights using the paint bucket tool). 

 

It will balance better if you make the tail heavier than the head. Adjust the infill/perimeters in different parts of the model to help with this (using modifiers in your slicer). Unfortunately, because of the internal perimeters inherent to multicolour printing, the head will be a lot heavier than the tail if printed in multicolour. You can compensate for this with very dense infill in the base, or simply help the model balance with a small piece of tape on the underside of the tail after printing.

 

Filaments used:

eSun PLA+: Black, Cold white, Fire Engine Red, Red, Yellow

 

 

 

 


 

Tags



Model origin

The author marked this model as their own original creation.

License