Wallmount Holder System for Jig, Oscillating and Sabre Saw Blades

Why?

I wanted to store the guidance for the Bosch GKS 12V 26 and different jig saw, saber saw and oscillating saw Starlock blades in one place.

Features:

• Space efficient solution to store a lot of blades

Requirements:

• Use any stiff material you like, I used PLA, the model is quite massive, ABS tends to bend
• I printed with a 0,6 nozzle, 4 walls and a higher percentage of your favourite infill, stability is key.
• Other than that no special requirements, no supports. Print it flat with the bottom side to the print bed. Be sure to master your dimensions accuracy on your printer. Tolerances are there, but not too much.. :-)

Enjoy, comments and critics are always appreciated :-)