Water cooling for saw to hose quick connector

Water cooling port hose connector Stihl: TS350 TS400, TS410, TS420, TS460, TS510, TS700, TS760 and TS800 saws
1h 9m
1× print file
0.20 mm
0.40 mm
6.00 g
6
44
0
284
updated September 22, 2023

Description

PDF

FIRST DRAFT NOT YET TESTED:

Water cooling port to Hozelok / Gardena hose quick connector, for water cooling of saws such as 

Stihl: TS350, TS350 AVE, TS360, TS400, TS410, TS420, TS460, TS510, TS700, TS760 and TS800 Cutquik Saws

Note that the thread length for the saw may need adjusting to suit your saw - just print at 100% infill and sand it down if so.

Thread on saw is I think a G1/4 (¼" BSP parallel).

Print with supports, 0.2 later height PLA should be ok. perhaps add extra layer detail to the threads

You'll need two o-rings 
* one standard o-ring 2.5x11 (OD: 16mm, cross section 2.5mm) for the hose quick disconnect
* one o-ring of unknown size for the saw end. Probably not needed as it'll just spray water everywhere anyway!

 

feedback welcome

Model origin

The author marked this model as their own original creation.

License