covered fidget-base-double stacked 6x2 magnets

Loved the original model and preferred the look of the covered model but my magnets were too weak after being covered by the top layers, so I made them twice as deep. Process is the same for assembly, add a pause before the top layers and insert magnets then finish the print. Uses 6x2mm magnets.

Also, I found printing with a 0.3mm first layer works best for covering the top surface with 2 layers for a better surface finish since my remix resulted in an overall .3mm increase in height to the model. I may also try fixing this height so the first layer height can still be 0.2mm. Still uses 0.2mm layers for the rest.

The button base and original button files are compatible with this as well. 

Printed this on my bambu lab p1s!

Loved the original model and preferred the look of the covered model but my magnets were too weak after being covered by the top layer, so I made them twice as deep. As a result, the base is also overall about .3mm taller. (sorry)