14/23 inner joint with hose connector

A TS (or NS) 14/23 inner joint with hose connector that follows the european ISO for standard joints

This model is intended to be printed in a resin printer since if printed with a FDM printer, layer lines could create problems in the joint and/or supports may be difficult to remove

The model walls have a 2.0 mm thickness and the hose connection is 8.00 mm in diameter (without the ridges)

It has been pointed out to me that it is not possible to connect the joint and the column with a clamp because there is no support on which it can grip, but I'm planning to rectify with a revised model

In the downlodables there is also a pre-supported file

How I Designed This

The model has been designed using Fusion360