Perfect amount of clearance now the back wall of my cabinet.
Angled heatbed cable cover (REMIX)
I remixed T1miverse's design so that screws and nuts are now flush with top surface. Recommended for LACK enclosure
115
806
18
4642
updated March 5, 2021
Makes
Comments
Cables inside it get bend quite a lot and putting it on is a bit tricky but other than that it's amazing!
Works well.
You just have to have one of these if building an enclosure. Great job. Super useful
After putting my printer in an enclosure I noticed that the heatbed cable was often being forced up against the back wall. Just a little bit of an angle would prevent it so I went looking for a solution. This model did exactly what I needed. I liked it so much that I printed a couple extra in case I replace my printer or want to give one away. The print was quick and easy using Prusament Matte Black PETG on a textured bed. Thanks for the model! --Harry
Needed longer screws and with the nuts being in the top part, assembly was not very easy.
