This is a simple case to relocate and replace the original LCD mount. V2 is a little too tall to go under the bed on my machine, but V3 is shorter, but slightly harder to print depending on your machine.
For Assembly, I mounted my LCD first, then attached it to my printer. Either way you do it, the clearances are pretty tight.
There is a slot on the side and in the middle of the back for the ribbon cable. Use the side slot when mounting to the right of the 4040 and the back when mounting to the left.
Printer Brand:
Creality
Printer:
Ender 3
Rafts:No
Supports:
No
Resolution:0.2
Infill:
20%
Notes:
Any material does the trick.
Category: 3D Printer PartsThe author marked this model as their own original creation. Imported from Thingiverse.