Sc1re

@Sc1re

Works great, I used a belt clip though as opposed to the same clip on both sides,

16

Sam

@Sam_339193

Thanks for this model, I like the fact it has a minimal footprint.

19

LowRunneR

@LowRunneR

Printed in PETG-CF. I hope they will keep its springiness.

21

fns720

@fns720

@LowRunneR Fingers crossed!

Easy print, works great!
Thanks for sharing !

17

stebaut0

@stephenhiras_1439037

40mm is the way to go. Could use more aggressive teeth.

Thank you 👍

printed in PETG with 15% infill and 4 wall thickness

5

aboboxcamper :D

@aboboxcamperD_296705

These clips are very useful.
So I already printed a bunch off the 40mm version (all in Esun petg), as I found out that the 30mm version is a bit to small for many motorcycle gloves. (edited)

Nice model

Nice model, and does the job well.

Printed in MatterHackers Orange PETG on a heavily modified Anycubic Mega S.

View one more comment

19

Luc Dunn

@phyzekiel

@fns720 Nothing personal. I think it would be nice with more teeth, and in PETG it works, but I think PETG may be too flexible. My leather gloves fell out a few times. I think I'll try PLA and see if the higher rigidity helps.

21

fns720

@fns720

@phyzekiel Thanks for the feedback, I really appreciate it.

I'm printing these from ABS with 5 perimeter shells and using with electrician gloves. Stays stiff enough after a year of daily usage.

Glove clip

Makes

Comments

Glove clip

Makes Add make

Comments

Makes