QIDI X-Smart 3 Side Spool Holder

Side Spool Holder due to space constraint at the back.
46
338
9
1216
updated September 18, 2023

Description

PDF

Hi all,

 

Due to space constrain in the office, I had to mount the filament on the side.

Just looking around for spool holders and thought i should just practice 3d modeling and use the mount from another designer.

2 type of spool holder

Using the original holder or another by itself.

Print it flat down (with tree/organic support for the holder that uses the original holder.

Do use a pcs of rubber or foam tape to hold it in place

Also use a PTFE tube to guide the filament without the two, there may be some feeding issue.

Print setting as you prefer.

Setting I used:

E220 B60

0.2mm Layer Height

15% infill, Grid

3 wall, 4 Top and 3 Bottom.

Thank you for viewing!

Tags



Model origin

The author remixed this model.

Support camera yi home qidi x smart 3
by Mimi
Original model was switched to draft or deleted

Differences of the remix compared to the original

Used the mount from Mimi to redesign the spool holder.

Thank you to creator!

License