PCB Holder

Simple PCB holder to hold your PCBs while you test them

Printed parts:

1. 1x Top
2. 1x Bottom
3. 1x Barrel

Mechanical Parts

1. 1x M4-40 screws - https://www.mcmaster.com/91290A174/
2. 1x M4 hex nut - https://www.mcmaster.com/90591A255/
3. 1x Compression spring - https://www.mcmaster.com/9657K317/
4. 1x 10x2mm magnet - https://www.amazon.com/gp/product/B09NHSM9R6

Assembly Instructions:

1. Insert the spring into the Barrel from the open side. It should sit in the grove
2. Insert the Top into the Barrel from the opposite side and push it through the spring
3. Insert the M4 bolt through the Top part
4. Insert the nut into Bottom part so that it sits in the hex shaped hole
5. Put the whole assembly together and compress the spring
6. Tighten the bolt all the way