Lithopane Frame 150x90mm - WS2812B

Easy to print, i recommend using supports as manual and selecting the small interior flat spot and using Organic supports

Materials:

• x12 3x2mm magnets (so you can swap pictures at ease
• WS2812B Addressable LED (132mm)
• USB WS2812B power cable
• x2 M2x3 self tapping screws
• WS2812B Splitter (to connect a strip without an end piece) or you can solder

Printing:

• 3-4 walls of a dark material like black
• Organic supports for the interior overhangs

Hints and tips:

• lightly insert magnets then if using PLA turn your bed to 100c and place on top to heat them up a little then press the base onto a hard surface to sink them in easier
• Slider has a rough tolerance of 0.25mm for a tighter and cleaner fit
• Dollar Store LED is available in Canada and is 75x46mm /w 8mm rounded corners
• Supports are included in the Slider versions for the slide sections and Organic are recommended for the interior flat pieces

Revisions:

Sept 16

• Added a slider version and updated the magnet tolerances for better fit