Bird seed feeder - repair pieces

A friend has a bird seed feeder in his garden. The front plate and feeder caps were worn out over time due picking by the birds. I designed some repair pieces to make it usable again. Additionally I provided the front plate in case you want to print it instead of getting it from a transparent material. 

Parts needed for assembly:

• 1x front_plate (print or make from transparent plate material)
• 1x printed_washer
• 1x printed_pin
• 2x feeder_cap
• 1x M3 washer
• 1x M3x14 screw
• 1x M3 threaded insert

Print instructions:

• Filament of your choice, I recommend PETG, ASA or ABS for use outside.
• Layer height of your choice
• Supports needed for the feeder_cap, rest without supports.
• You might want to scale up the feeder cap for a snug press fit.

Assembly:

• Insert the threaded inset into the pin.
• Install the pin with pin on the outside and the printed washer on the inside.
• Insert the feeder caps.
• If you find the feeder caps to loose you can fixate them with some super glue.
• Alternatively check your shrinkage and scale in the slicer for a snug press fit.

I would be happy to see some of your makes posted :)

Source files in the Alibre Atom format is available but the website does not allow the upload. If you need it send me a message.