Fully parametric plant support

Support for plants around a circular base. Fully parametric (see the attached scad file), to print any size.
18
46
0
311
updated September 8, 2023

Description

PDF

Support for plants around a circular base. Fully parametric (see the attached scad file), to print any size. Print upside down, no support needed whatsoever.

Scad file parameters:

ParameterDescriptionDefault valueUnit
inner_diameterDiameter between the feet - if your plant has some sort of circular base you want to put this support around of, this is the value you're after. This is also what defines the main diameter.56mm
hole_diameterDiameter of the hole for the plant. Be mindful that depending on the angles below, the opening will most likely be smaller than that.5mm
ring_widthWidth of the outer ring.11mm
supportsNumber of supports. Less supports will mean a larger opening to the centre hole, as the angle of the opening is the angle between two supports.5n/a
support_angleAngle each support occupies. Larger angle means larger supports.15Degrees
support_heightHeight of the supports30mm

Tags



Model origin

The author marked this model as their own original creation.

License


Highlighted models from creator

View more