Hey mate! Could you share the f3d file so we can get use of the parametric design? Thanks a lot :)
UMB - ULTIMATE MODULAR BOX SYSTEM! More than 30 parametric parts for you customize your storage
Use the 6 pre-assemble boxes, 12 accessories and 12 sides to build your setup or customize the parametric files!
In the contest Organization Tools
2,311
3581
6
41 k
updated February 20, 2021
Makes
Comments
These are pretty clever and I like the interlocking mechanism. I'm running into one limitation (or user error, never rule that out). For the pre built boxes with positive and negative on 2 sides each it makes it so squaring a few together isn't doable without so cutting and elbow grease.
Any chance you could make a negative side file that goes fully through?
@R3Design_120938 Also what is the best way to take the individual piece walls and have them "snap" to each other just right? Im pretty new to fusion but I am guessing in there maybe? My slicer doesn't quite have a great move to coord system.
The drawer is tight, I used 99% X/Y dimensions and it fits better. Could have tightened this fitment a bit but decided not to since I printed at least three drawers lol
I shrunk this down since I don’t plan to connect it with other boxes, this makes for a great box even when it’s all alone. I did shrink the inside box to about 98-99 percent since I saw a few comments saying it was a very tight fit
Gostei, maneiro seu projeto!
Worked great until I tried printing a drawer and it was too tight. Could have been my fault as I warped my print bed by accident -- I have to revisit for sanity.
Default size boxes don't fit the default size drawers.
Super nápad
The model images on here don't do the shape of the boxes justice. It's hard to see their geometry.
It is a good idea there should be accesories for this so good i printed one 5x5 it was very good just gotta to print hte driver
hello, to print 10x5 vertical or 10x5 drawer, do you need supports? Are the pieces oriented right? thank you