Box for Revo Nozzles

A box for storing E3D Revo nozzles. with labels and color coding for the basic 4 sizes, holds 3 of each size.

Fits the standard Revo nozzles, should fit ObXidan, high flow and high temperature nozzles. don't know about the longer belt nozzles.

Designed to be printed with no support and no infill. with a 0.4mm or a 0.6mm nozzle (the box in the picture was printed with a 0.6mm nozzle). 

Use 1.75mm filament for the hinge at the back and for the latch, you might need to clean up the inside to make it fit (I recommend a 2mm drill bit).

The top and bottom models should be printed with the solid closed side on the buildplate and the open side on the top. the bar model should be printed flat with one of the long flat sides on the buildplate. the latch should be printed standing on its side. 

The box 3d model has a big cavity inside it, this is intentional, it causes a solid “roof” and “floor” inside the box, this both prevents the problem of the hotend knocking down the tubes during printing and adds rigidity to the box without any infill.