Sovol SV06 Lack enclosure Remix

Some adjustments to the original remix of the original Lack enclosure for Sovol SV06.
12
59
0
879
updated December 11, 2023

Description

PDF

 

This was my first real 3D printing project after a few initial test prints! It was a very interesting project where the parts were mostly pretty easy to print, but also taught me a lot on the subject.

 

The prints for the door knobs and bottom corners with hinges need to be paused for a drop-in placement of the magnets / hinges respectively and then resuming the print.

 

I used the original models from the Lack enclosure for the lower table and the spool holder.

 

NOTE! With any enclosure system with Sovol SV06, the heatbed cable is going to be under a lot of stress everytime the bed moves all the way to the back, as the cable points straight outwards from the bed. My bed thermistor broke (got a new one from Sovol support!) and I read similar experiences from other people too. With the new bed I immediately printed a cable guide found from this reddit post: https://www.reddit.com/r/Sovol/comments/11nuphy/sv06_heat_bed_cable_touching_ikea_lack_enclosure/ (unfortunately the model is only linked on this thread as a download link, not found on Printables). This model redirects the heatbed cable to the side, and so far everything seems fine!

 

Model origin

The author remixed this model.

Differences of the remix compared to the original

  • Made the enclosure taller to fit a concrete slab underneath the printer
  • Redesigned the door knobs to use with Clas ohlson's door magnets

License