TwoTrees Sapphire/Sappheiros Pro/Plus/SP-3/SP-5 Hotend Rear Cover

This is a cosmetic upgrade for Two Tree's Sapphire Pro/Plus Hotend. This will hide those ugly wires and give support…
6
14
0
440
updated December 22, 2023

Description

PDF

This is a cosmetic upgrade for Two Tree's Sapphire Pro/Plus Hotend. This will hide those ugly wires and give support on top for those wires.Do NOT forget to install the spacer, this cover will prevent your Y axis from homing because the rear cover will prevent your printer from touching the limit switch

You will need to buy the following screws:

Materials

  • 2x M4x8 (to attach spacer)
  • 2x M2x4 (to attach rear cover to top piece)
  • 4x M3x4 (for wire harness bracket)

Install Steps

  • Install spacer first
  • Install top piece
  • Remove the 4 rear screws from the fans and the top 2 screws that hold the hotend onto the carriage
  • Screw those screws into the rear cover
  • Place the rear cover in-place and tighten screws
  • Place caps over the holes on the rear cover, and attach the rear bracket onto the wire harness

Print Settings

Printer:

Sapphire Plus

Rafts:

No

Supports:

Yes

Resolution:

0.16

Infill:

25%

Filament:

Polymaker Polyflex PLA

Black

Category: 3D Printer Parts

Tags



Model origin

The author marked this model as their own original creation. Imported from Thingiverse.

License