Just finished a make and it is great! The base I printed however isn't quite tall enough, almost like the last few layers didn't print, any idea why? Brilliant design though, thank you!
Nintendo NES - Raspberry Pi 3 Case
This is yet another Nintendo NES Raspberry Pi Case. I know there already are some other cool models here on…
51
316
1
2435
updated February 19, 2021
Makes
Comments
Amazing. Thank you so much! (i wish that it was easier to acces the usb ports, i had to make a few modifications) (edited)
It looks good and printed easily, but after you mount the pi into the case there is not enough room between the USB port and the edge of the case to plug in a usb controller.
View one more comment
coolcow hey thanks for that.. any chance you could post of photo of your solution? I just have a couple of usb controllers that look like original snes controllers. Not sure how to mod those to angled plugs ? (edited)
@Heisenberg61_173254 This is a very old comment but just incase someone else comes across this there are many USB angle adapter options. I would probably go with something like these and maybe route them to be behind the flap for easy access https://www.amazon.com/Oxsubor-SuperSpeed-Female-Extension-Cable/dp/B0793P8XJK/ref=sr_1_14