BRIO compatible ramp

Most of the BRIO compatible ramps start and end with a flat track. This 30 degree ramp gives you the possibility to build a continous ascending/descending train track.

There are two ramps, one which has the track on the inside and the other on the outside. You need both as a start/end track. Use some straight tracks and the connectors to hold them together. 

The connectors are not very tight so that children can easily fit them (and also they fit on the curved ramps). However, with the weight of the track, they should hold the tracks together nicely. Don't try to “snap” them into the track (they may break), but just slide them into one track first, connect both tracks and slide them back so they are centered.

Print with 0.2mm. Supports are needed (also for the connector). Let the flat part point to the bottom so that you have a nice surface on the track itself.