Light up fence corner

-A light up replacement for fence corner pieces. 

-Modell is designed to fit all hollow fence corners with a inner diameter of 57mm.

-The main piece is fitted with a small solar cell (32mm x 32mm). You also need a aaa rechargable battery ,a small circuit and a Led (i extracted them out of small solar lamps build for outdoors (found them in a cheap store (if youre german i bought them at Teddy)).

-The battery and Led holder has to be glued onto the four corners of the top (the one with the solar cell) with hot glue, super glue or any glue that holds.

-For it to be watertight i would recommend glueing the Lid (stl called waterkeeper) with hot glue at the seams (doesnt need to be 100% watertight).

-Printed them all with 0.16 layer hight to make sure the top (with solar cell) is water tight.

-The hinge requires a small piece of 1,75mm filament and should be rotated on its side for printing.

-has to be printed with a clear/transparent filament to let the light of the Led shine throug.(I used a clear glow in the dark filament)