If you plan on doing this mod keep in mind that your filament may have an increased amount of friction while inside the bowden tube. Since the spool holder now rests above the foot that the tube runs inside of. I will be posting another mod that will replace the top plastic panel on the back of the printer to reduce this friction. There will be no run out sensor since I do not use one. Remixes will be available. You will also need a printer bigger then the V0 to print the other mod (220mm x 80mm minimum bed size). Keep this in mind before doing this mod.
(introduction)
Since I modded my v0.2 electronics a bunch I felt that bolting and un-bolting the back of the printer was annoying. This mod uses similar hinges, magnets and handle as the front door but is put on the back side of the printer. These hinges are remixed to allow for smother opening and closing. The spool holder will also be moved to the right side of the printer and the hinges will be on the left. (assuming you are facing the printer from the front). The STEP file will be included with all of the stls.
(file names)
The stls named “clips” are for the parts that go onto your original back plate. The stls without this added name get bolted onto the left side of your printer (assuming you are facing the printer from the front) replacing the existing lexan “clips”. The one step file is the entire v0.2 with this mod included.
The author marked this model as their own original creation.