i remixed the apple watch base to fit the charger (33mm) for the SamSung active 2 watch 44mm version. i enlarged the hole for the USB end as well.
I printed it quickly and everything fits fine. rather than tweak it to make it perfect I added a small 1" piece of black electrical tape on the back edge of the charger and now it fits perfectly snug without scratching.also added a small amount on the bottom too because the iphone cord is evidently larger, but this was same issue with original design too.
I also added a hole in the rear to push the charger out, but it's probably not needed.
it took 20 mins to modify and 3 hours to print'
i remixed the apple watch base to fit the charger (33mm) for the SamSung active 2 watch 44mm version. i enlarged the hole for the USB end as well.
I printed it quickly and everything fits fine. rather than tweak it to make it perfect I added a small 1" piece of black electrical tape on the back edge of the charger and now it fits perfectly snug without scratching.also added a small amount on the bottom too because the iphone cord is evidently larger, but this was same issue with original design too.
I also added a hole in the rear to push the charger out, but it's probably not needed.
it took 20 mins to modify and 3 hours to print'
Printer Brand:
Prusa
Printer:
i3 MK2.5
</div>Rafts:No
Supports:
No
</div>Resolution:0.2
Infill:
i used 30% butt could do with much less
</div>The author marked this model as their own original creation. Imported from Thingiverse.