A stand to fit the Samsung Galaxy Watch 6 charger that is slightly smaller than the watch 4 and 5 chargers.
Added a file for Watch 4 and 5 chargers.
I did these at 10% infill, add more infill to make them heavier and have better stability when the watch is on the charger.
I have noticed a difference in fitting between brands of printers, if yours is a little loose then use masking tape to shim it up better.
I have updated this with a small support shelf because sometimes the magnet isn't strong enough to hold a watch with a case on it. Shelf is at about 1 inch from center radius. (For the 47mm watch, I don't have the smaller watch to know the sizes needed on the outside Diameter with a case. Make a comment and let me know if you want a different size with your measurement and I'll adjust it.)
Added new files with a shorter shelf at 40 degrees instead of 60 to make room for watches with a cover.
The author marked this model as their own original creation.