Low-Poly Star Wars characters

A set of low-poly figurines of Star Wars characters
In the contest Low Poly
181
563
4
2593
updated August 17, 2023

Description

PDF

This is a set of 3 (and more coming) low-poly figurines from the Star Wars franchise.

It currently features:

  • Baby Yoda / Grogu,
  • Mando,
  • Darth Vader.

Printing settings

For the Baby Yoda:

  • Print it standing,
  • Supports enabled (you can use support blockers for a lot of parts, they are mostly needed for the hands and one of the ears),
  • Layer height: 0.15mm
  • Infill: 20% cubic subdivision, but lower would probably also work
  • Print time: Around 5 hours
  • Be careful about the right hand when removing the supports!

For the Darth Vader:

  • Print it standing
  • Supports enabled (I recommend using tree supports)
  • Layer height: 0.15-0.20mm
  • Infill: 20% cubic subdivision, but lower would probably also work
  • Print time: Around 6 hours

For Mando:

  • Print it standing
  • Supports enabled (tree supports are mandatory)
  • Layer height: 0.10-0.20mm
  • Infill: 20% cubic subdivision
  • Print time: Around 4 hours

You can easily scale up or down all the models.

Bonus: Book Stand

All 3 figurines are compatible with the book stand that is also attached, so that you can use it as a nice decoration piece for your bookshelf.

Here are the printing recommendations for the stand:

  • Print it on the side, this will make it stronger when it comes to holding the books,
  • Supports enabled (only needed for the pin, it almost doesn't add any time / material),
  • Bed adhesion: A brim may be needed, depending on your printer / filament,
  • Layer height: 0.2mm (you can probably go higher)
  • Infill: 100%, it needs to be strong to hold the books
  • Print time: Around 10 hours

Tags



Model origin

The author marked this model as their own original creation.

License