Time Piece from A Hat in Time

Create your own bird movie prop, no eBird required! Time piece is 9cm high

Print instructions

1. Supports are compulsory for the glass and struts.

1. Print out the glass (x1) in a transparent material and make sure you use 'Vase mode' on your slicer of choice. 2 shells at 0% infil will also work in a pinch.

1. Choose one of the two strut files. One has an additional base to help them stick to the bed (strongly recommended).

1. Print the strut file once (it has three struts) with at least 20% infil and 3 shells. They'll be fragile otherwise.

1. Print out the plates twice, any print settings for these.

1. Sand down, fill, sand again, prime, and paint as desired.