This is a remix of two designs to get the best of both for my DeWalt Table saw with metric nuts and bolts.
Following Designs are used:
Sliding Block:
www.thingiverse.com/thing:3973092
The block was dapted to fit for the DeWalt 7491 & 7492 and the size of the hex nut was adapted for a metric M8 hex nut.
Feather Bord
www.thinagiverse.com/thing:2832564
The legs of the board are extended. The Knob is adapted for a metric M8 hex bolt.
Notice: for the sliding block I enable the PrusaSlicer Ironing feature (for test purpose) looks very nice. One picture shows the same Block with and without ironing. I love this feature.
PETG
40% Infill
0.3mm layer height
Ironing (partiel)
The author hasn't provided the model origin yet.