Thread die holder for 20 mm dies. Fits on lathe tailstock spindle with 30 mm outer diameter.
This is a remix of a design by Marius Hornberger. https://www.thingiverse.com/thing:4625352
I changed it to fit 20 mm x 7 mm dies. Additionally I added M2-screws to increase the part strength. The main load goes on threads along the layer direction, which could cause shearing the holder. The M2 screws prevent the print from delamination.
Tools:
M4 thread cutter
(M4 thread cutter - optional)
Hardware:
4x M4x16 cylinder head screw
(4m M2x16 countersunk screw -optional, when used: tighten them before cutting the M4 threads)
PLA; 0.2 mm layer height; 0.4 mm nozzle; add a modifier to the top section (see photo) and increase to 6 perimeters, 7 top layers and 25% infill
The author remixed this model.