Three piece model rocket
Printer Brand:
Prusa
Printer:
Rafts:
No
Supports:
Yes
Resolution:
0.15 layer height
Filament:
Overture PETGBlack
Notes:
Bed Temp:
Fin Can infill: 40% Nose and Body infill: 0%
Non-printed parts
The recovery system was taken from a Estes model rocket kit. The rubber shock cord was tied between the fin can and the nosecone, going through the body tube. The parachute was tied to the middle of the of the shock cord.
Rocket on the launch pad. Tape in the middle to ensure it separates correctly.
OpenRocket design
OpenRocket simulation
The author marked this model as their own original creation. Imported from Thingiverse.