GD-R14 Aftermarket Garage Remote Control Cover

This is the snap in cover for the dip switches on this remote.
1
9
0
238
updated August 5, 2023

Description

PDF

This cover may fit other openers with this similar case. It does fit tight and may need a little carving and sanding to fit. Since the tabs are an overhang and I did not use supports they bowed down a little. I used a pocketknife to trim the sag away. I used generic PLA at 100% infill. Takes about 15 to 20 minutes to print.

Tags



Model origin

The author marked this model as their own original creation.

License