Wiha Screwdriver Stand / Rack / Organiser

I just saw the Inbus stand / rack / organiser thing and decided to remodel it for a Wiha set of screwdrivers I've owned for years and always thought I should make something for. 

• Holes are cut to fit the exact screwdriver set and in the order shown in the photo (left group at rear, right at front). 
• I reduced the amount of chamfer compared to the Inbus model to help ensure better bed adhesion 
  • this is probably a longish print, no one wants it to fail and curl cos there is only 1 mm on the first layer. 
  • check the model carefully when orienting and slicing, place it on the bed on the rear edge - the rear has less chamfer than the front edge to give it more material on the bed

UPDATE 05/08/2023: added 2nd model a bit smaller since the first is taller than it needs to be.

PRINT: 

• orientation on bed as described above
• PETG, 0.6mm nozzle, 0.4mm layer height, 3 perimeters, 2 top and bottom, 15% adaptic cubic infill, no supports unless your bridges are really bad (this all gives it a decent bit of weight and smooth paths)
• Took ~4 hours for me at 13.5mm3/s volumetric flow rate (was a good torture test to check hotend / extruder can handle this)
• Turned out real nice n clean and feels like a proper solid bit of kit that won't wobble or fall over easily. 
• Screwdrivers are a good snug fit for me, if your bridges on the holes are a bit oval/droopy then carefully open them up (file / sandpaper / drill). 

Be nice to see other's makes and let me know if you have any (constructive) feedback … 

Feel free to donate via Paypal if you appreciate this and would like to help me make more by keeping me in filament  

took original as base idea and remodelled from scratch for Wiha screwdrivers