Articulated Robot in 11 Minutes (enhanced)

First of all, this is not my own design. If you like it, please send a tip to NirDobovizki.

Having identified some drawbacks in the original design regarding easy printability I pulled the STL on TinkerCAD and took a few minutes of my spare time to make some minor modifications to enhance bed adhesion.

While I was at it I also realized that there was enough space left in the body to make the robot head articulated, too!
So I simply copied one of the arm links there. Works like a treat!

Printing time is (only) a few seconds longer than the original V2 version; actually Cura shows both the old and new one as "11 minutes" with my settings.
I did not manage to print a robot V2 or V3 in under 10 minutes that actually looked nice.

Print Settings

Rafts: No
Supports: No
Resolution: 0.2mm
Infill: 15%
Filament: bq PLA blue 
 

Notes: 

Make sure to enable the "Print Thin Walls" setting in your slicer, otherwise the first layer will not be sliced as required!Cura

Having identified some drawbacks in the original design regarding easy printability I pulled the STL on TinkerCAD and took a few minutes of my spare time to make some minor modifications to enhance bed adhesion.

While I was at it I also realized that there was enough space left in the body to make the robot head articulated, too!
So I simply copied one of the arm links there. Works like a treat!