Honda Odyssey Key Case

Other shell for Honda Odyssey Key
7
62
1
386
updated September 5, 2023

Description

PDF

I remixed this Key Case from SirHair 

Honda Key Fob shell by SirHair | Download free STL model | Printables.com

I wanted the holes for the Key ring to be a bit bigger so I made the hole bigger and shaved a bit off the top and bottom by the holes so my key ring would move around better.

I also shaved a bit off the sides and the bottom of the case so that the form factor is a bit smaller.

When I was attempting to get the original screw out of the first version I printed, I stripped the screw and I couldn't get it into the new or old case again.  Since I was leaving for vacation early the next morning I put a small dab of original Polyurethane Gorilla Glue on both sides of the metal key insert put the case together and clamped it overnight.

The case has been holding up great and I figure when I need to replace the battery I'll just cut through the side where the two halves snap together pry it open clean up the metal insert and then print a new case.  

Model origin

The author remixed this model.

License