Split cable guide / organizer for THE 100 v1.1

Note: This is only for v1.1 of The100 which has locations on the back frame for cable guides. 

The cable guides are super useful but I found them a little too tight to run connectors through when they were installed on the printer, and you also have to remove them from the printer to redo any cabling. 

This remix has a gap in the clip so you can add/remove cables without removing the clips. They're also wider to give a little more room for cables. 

I installed them using m3x6mm screws. There are holes in the front of the clip to make attaching them easier. No supports required when printing.