Bigtreetech TFT35 SPI for Voron V0

This is a display mount for a BTT TFT35 SPI to a V0. 

Two parts in total, around 1,5h print time. No supports, you still need to arange them yourself; Cover (stl name v02_spi_display_1 and blank) on its face and the mount itself standing (v02_spi_display_2; angled display flange pointing upwards). Later one might benefit from a brim.

Print settings: minimum 3 walls to avoid tiny solid infill, minimum 3 tops/bottoms; everthing else doesnt matter

Possible colour change between layer 3 and 4 for the V02 cover.

tips for touch calibration if you have a shifted touch:

Tft35 SPI touch calibration : r/BIGTREETECH (reddit.com)

The display shouldnt need rotating

Required hardware: 

2 M3x6 (stock display/skirt)

2 M3 nuts (already in the frame from stock skirt or display)

4 M3x8 or M3x10

longer ribbon cable 

or 

3,6m of wire+  solder or jst xh 2,54 pitch 10 pin; Dupont connectors

screen manual: TFT35-SPI/v2 at master · bigtreetech/TFT35-SPI · GitHub

BTT PI manual: GitHub - bigtreetech/BTT-Pi