Single piece hair bow with hair tie attached, using TPU. Stays in hair pretty well. Printed as one piece.
Printing instructions
- 0.4mm nozzle
- Tested with 95A shore hardness (OVERTURE TPU)
- 20% infill (you can change this, but I wouldn't go lower than 10%)
- Infill type: Rectilinear (you can change this to whatever you think looks good!)
- Infill Width 0.8mm
- Layer height: 0.16 mm
- First layer height: 0.2mm
- Solid layers, top and bottom: 0 ***IMPORTANT***
Tags
The author marked this model as their own original creation.