Does not properly close, even if you align it perfectly top v2 isn't tall enough (or the bottom isn't deep enough.
LTT Screwdriver and Bits Gridfinity Box
Remix of the parametric gridfinity box with the LTT logo to be used with https://www.printables.com/model/290486
45
174
2
1692
updated December 30, 2024
Makes
Comments
View 3 more comments
@MacBoy__Pro_842438 the link isn't dead, it works fine for me. It simply redirects to https://www.printables.com/model/290486-ltt-screwdriver-extra-bits-gridfinity-storage
@PatvdLeer Interesting, the link was giving me a 404 yesterday.
I think the issue is due to how the tool sits in the insert. I've had no issues if one of the flat sides of the screwdriver is facing upwards as shown in the attached photos, though if the tool is turned I encounter your issue. I admit it is frustrating to try and align the tool "perfectly" just to close the lid.
You can try editing the f3d file I uploaded to increase the spacing on the lid, but you might run into issues where the bits will come loose inside the case. If I remember correctly, I had it as far back as I could on my first attempt removing the grid pattern and the bits came flying out when moved around.
Note: My case is roughed up because it's been in a tool bag for over a year (edited)
It would be great if somebody could make a box with gridfinity on the bottom as well. I'm not good enough with fusion360 yet, but would love a box that would be great in my drawer ánd on the go
What size screws are you using for the latches?
@MattCooper M3x30 SHCS
the insert has disappeared could you re up it please?
View 3 more comments
@SILENCEuk_504295 I found the issue, the link has an extra '.' included leading to the 404. I've updated it in the description, but try https://www.printables.com/model/290486
@MacBoy__Pro_842438 oh yeah i missed that too ! Thanks
Case printed in Elegoo Black PLA+, LTT Logo Inlet printed in Orange Inland PETG+
